Ski-Doo Formula S 1998, Shop Manual

Page: 159 / 338

Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
05-03-10
Apply retaining compound outside of bushing then
press it down to counterbore from sliding half
side. Use spring compressor (P/N 529 0151 00)
and appropriate flare tools.
Start driving bushing into spring cover.
1. Note upper tool side
Press bushing.
1. Note upper tool side
ASSEMBLY
NOTE: This drive pulley is lubrication free. Do not
lubricate any component.
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (P/N 413 7029 00) on threads
and under head then torque to 15 N•m (133
lbf•in).
26,27,28, Calibration Screw, Washer
and Locking Nut
When installing calibration screw, make sure to
install washer as shown.
1. Washer
Torque locking nut to 10 N•m (89 lbf• in ).
-
CAUTION
Bushing must be bonded with retaining
compound.
-
CAUTION
Insert bushing from sliding half side (inner)
of spring cover.
A01D2MA
529 0313 00
529 0312 00
A01D2NA
529 0313 00
529 0312 00
1
A01D2OA
529 0313 00
529 0312 00
1
A16D07A
1