Ski-Doo Formula S 1998, Shop Manual

Page: 241 / 338

Section 06 ELECTRICAL
Subsection 07 (TESTING PROCEDURE)
06-07-4
3. IGNITION SWITCH, TETHER
CORD SWITCH AND
EMERGENCY SWITCH
TESTING
Disconnect connector housing 1-04 from engine
and check resistance as indicated in IGNITION ta-
ble.
If readings are acceptable, go on to next step.
If readings are inadequate, individually check each
switch as follows.
Ignition Switch (key)
Disconnect switch housing. Using a multimeter,
check between “MAG” and “GRD” terminals if
the circuit is open (0.L
M
Ω
) in operating position
and if the circuit is closed (0
Ω
) in off position.
If readings do not correspond to the above-men-
tioned indications, replace switch.
If readings are acceptable, check other switches.
Emergency Switch
Unplug switch block connected to main wiring
harness. Check using a multimeter. Connect
probes to BLACK/YELLOW and BLACK wires.
The multimeter should indicate an open circuit
(0.L
M
Ω
) in operating position and a closed circuit
(0
Ω
) in off position.
If readings do not correspond to the above-men-
tioned indications, replace switch.
If readings are acceptable, check other switches.
Tether Cord Switch
Unplug switch block connected to main wiring
harness. Check using a multimeter by connecting
probes to BLACK/YELLOW and BLACK wires.
The multimeter should indicate an open circuit
(0.L
M
Ω
) in operating position and a closed circuit
(0
Ω
) in off position.
A05E06A
A05E07A
A05E08A
A05E09A