Operate
6.2 Parameter description
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
71
6.2.2
"2 Setup" main menu
This menu is used to make settings regarding the control response, setpoint processing,
inputs and outputs, and display contents. The following table contains an overview of the
menus and parameters:
2.1 Special application
2.4 Extended setup
2.1.1 Deadband
2.4.1 Setpoint
2.1.2 Tight closing
2.4.1.1 Direction
2.1.3 Lower tight closing limit
2.4.1.2 Limiting setpoint rate
2.1.4 Upper tight closing limit
2.4.1.3 Setpoint rate up
2.1.5 Lower travel range limit
2.4.1.4 Setpoint rate down
2.1.6 Upper travel range limit
2.4.1.5 Characteristic curve
2.1.7 Valve direction
2.4.1.6 Current 0%
2.1.8 Display mode
2.4.1.7 Current 100%
2.1.9 Failure reaction
2.4.2 Free characteristic curve
2.2 Inputs/outputs
2.4.2.1 0% Turning point
2.2.1 DI 1 Function
2.4.2.2 5% Turning point
2.2.2 DI 1 Direction of action
…
2.2.3 DI 2 Function
2.4.2.21 100% Turning point
2.2.4 DI 2 Direction of action
2.4.3 Controller parameters
2.2.5 DO 1 Function
2.4.3.1 Controller self-tuning
2.2.6 DO 1 Pulse length
2.4.3.2 Dynamic
2.2.7 DO 2 Function
2.4.3.3 Kp Up
2.2.8 DO 3 Function
2.4.3.4 Kp Down
2.3 Limit values
2.4.3.5 Ti Up
2.3.1 A1 Alarm limit
2.4.3.6 Ti Down
2.3.2 A1 Direction of action
2.5 Display
2.3.3 A2 Alarm limit
2.5.1 Contrast
2.3.4 A2 Direction of action
2.5.2 Orientation
6.2.2.1
"2.1 Application"
Use this menu to adjust the positioner to your individual control task. The parameters are set
in the factory so that you only have to make a few settings for adjustment purposes. The
following table contains an overview of the menus and parameters:
2.1.1 Deadband
2.1.6 Upper travel range limit
2.1.2 Tight closing
2.1.7 Valve direction
2.1.3 Lower tight closing limit
2.1.8 Display mode
