Operate
6.1 Operation overview
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
61
6.1.5
Changing operating mode
Requirement
Positioner is initialized, and you are in the measurement view.
Figure 6-5
Example: Measurement view in automatic mode
Procedure
1.
Once the display shows the measurement view, press .
2.
The positioner changes operating mode.
– Manual mode
In manual mode, the positioner does not react to the setpoint input by the 4 to 20 mA
signal. The flashing hand symbol in the display and the "Manual mode" status
message indicates that you are in manual mode:
The button functions in manual mode are as follows:
Use and to move the actuator.
Use to change to the navigation view and then further to the parameter view.
Use to change from manual mode to automatic mode.
– Automatic mode:
The button functions in automatic mode are as follows:
Use to change to the navigation view and then further to the parameter view.
Use , or to change from automatic mode to manual mode.
See also