10. RADF
(1) Adjust any center misalignment.
Set the original on the tray and make a copy. When the copy slips out
of the center as Fig. 1 or Fig. 2, open the ADF cover, loosen the two
mounting screws and adjust the tray to correct position.
★
Fig. 1
Move the tray in the direction A and secure it with the two mount-
ing screws. Make sure that it is centered properly.
★
Fig. 2
Move the tray in the direction B and secure it with the two mount-
ing screws. Make sure that it is centered properly.
(2) Document lead edge position adjustment.
•
The document lead edge position for RADF can be determined
using the SIM 53.
•
For it had been factory set that the lead edge should stop on the
location 8, but it may be needed to make adjustment. It can be
adjusted within a range of 8mm (8 steps) at the stopper side and
7mm (7 steps) at the glass side. Adjustment can be done for each
mode of single sided, double sided, and light weight paper.
•
Setup example
(1)
If the lead edge of the document was still not to the stopper,
enter an optimum value.
(2)
If the image at the lead edge of the document were to deform,
enter an optimum value to move to the glass side.
(3)
If the document were to override the stopper, enter an optimum
value to move it to the glass side.
Mounting screw
Mark
A
B
Center of document
Center of copy (first copy)
Fig.1
Fig.2
Center of copy (first copy)
Center of document
0
7
1
2
3
4
5
6
8mm
7mm
9
10 11 12 13 14 15
8
Stopper
Glass
Document
Glass
Stopper
Stopper
Glass
Document
Stopper
Glass
Document
8 – 17