
B. Adjust any center misalignment.
No adjustment should be needed for the unit as it is factory-set.
However, if it is off-center, adjust it according to the following proce-
dure.
Make a copy. If it is off center as shown in fig. 1 or fig. 2, loosen the
two center adjuster mounting screws attached to the cassette and
adjust it following the prcedure below.
[Note]
When mounting the center adjuster, make sure that the mounting
screws are positioned in the same spot in their respective slots.
When off center as shown in fig. 1
Move the center adjuster in direction A and secure it with the two
mounting screws. Make a copy to check whether it is centered
properly.
When off center as shown in fig. 2
Move the center adjuster in direction B and secure it with the two
mounting screws. Make a copy to check whether it is centered proer-
ly.
(10) Copy density check
After installing the copier, check the copy density. If the density is not
in the specified range, adjust it.
(Refer to the print quality adjustment.)
(11) Installing sorter (SF-S53N)
<option>
Center adjuster
Direction A
Direction B
Center adjuster mounting screws
Fig. 1
Center line of the first copy image
Paper center line
Fig. 2
Paper center line
Center line of the first copy image
Included parts
Caster screws
(M4 x 60): 8
Sorter mounting plate screws
(M4 x 12): 2
Rail mounting plate screws
(M4 x 14): 2
Rail screws A
(M4 x 6): 2
Rail screws B
(M4 x 6): 1
Bracket screws
(M4 x 10): 2
Caster spacers: 4
Rail: 1
Sorter mounting plate: 1
Rail mounting plate: 1
5 – 15