Main
Sub
Item
Content
Adjustment
code
code
range
50
05
Adjusts the
leading edge
position of the
image (printing
by printer).
Adjustment range
Leading edge adjustment value (print) RRC-P:
0
∼
99
The image moves 0.1 mm toward the trailing edge for each “+1” in adjustment
value.
The image moves 0.1 mm toward the leading edge for each “–1” in adjustment
value.
• [CASSETTE SELECTION] key
(a)
Operation/display
[PRINT]:
If the entered value is valid, the current setting is updated. If
the entered value is not valid, the input field is cleared and
the error buzzer sounds.
If any value is not entered, copies can be made.
[0-9]:
Enters new settings. (The setting is displayed on the
COPIES SELECTED display.)
[CASSETTE SELECTION]: Switch over paper feed modes.
[C]:
Clears the input field.
[PAUSE]:
No setting is made and the sub code input screen is dis-
played.
To clear the image leading edge position adjustment mode:
1. Turn ON the [CA] key, or
2. Turn ON/OFF the main switch (on the left-side of the copier), or
3. Enter the simulation mode and press the [CA] key to exit the simulation mode.
50
10
Adjusts print
off-center
(manual feed,
cassette, ADU).
[Content] The print off-center can be adjusted (manual feed, cassette, ADU)
If the [PRINT] key is pressed after entering a sub code, the copier exits the
simulation mode and starts warming up. After warming up, the copier becomes the
copy ready state. At this time, the current print off-center setting is displayed in the
[XX] area. However, if the warming up action is finished by another sub code, the
shading/process control is omitted.
The setting can be changed with the numeric keypad. If the [PRINT] key is
pressed after entering a new value, the value is set as a new setting. You can
change setting item pages with the [MAGNIFICATION RATIO AUTO SELECT]
key, move from one item to another with the [
→
] key, and change the settings. The
paper feed mode currently selected is displayed in the [XX] in reverse video.
If the [PRINT] key is pressed without entering any setting, a copy can be made by
using a sheet of paper in the paper feed mode currently set in the input field.
However, the multiple copy function is not available.
Adjustment range
Print off-center (Copier lower tray)
OFP_T1:
0
∼
99
OFP_T1: 0-99
Print off-center (Desk upper tray)
OFP_T2:
0
∼
99
OFP_T2: 0-99
Print off-center (Desk lower tray: LCC)
OFP_T3:
0
∼
99
OFP_T3: 0-99
Print off-center (Manual feed tray)
OFP_M:
0
∼
99
OFP_M: 0-99
Print off-center (ADU)
OFP_D:
0
∼
99
OFP_D : 0-99
WARMING UP.
PLEASE WAIT.
50
TRAY ADJUSTMENT
RRC_P [XX]
50
0~99
MFT ADJUSTMENT
RRC_P [XX]
50
0~99
9 – 73
