d. Hook the CL spring on the front and rear frames of the fusing unit.
Make sure that the CL spring presses the bearing as shown in the
figure below.
e. Reinstall the fusing cover which was removed in step a, and
secure it with screws.
f.
Place the guide pin at the bottom of the fusing unit in the groove
of the copier. Holding down the front cabinet, push in the fusing
unit slowly as far as possible.
At this time, make sure the positioning pin of the copier frame is
securely installed in the positioning hole in the fusing unit fixing
angle. Secure with the fixing screws which were removed in step
(3) A. b., and close the paper exit unit. Reinstall the front cabinet
band which was removed in step (3). A. a. Close the paper exit
unit.
(4) Cleaning the charger
A. Cleaning main charger unit electrode
a. Holding down the hook of the main charger unit, release the lock.
Pull out the main charger unit from the copier and remove it.
b. Remove the screw securing the electrode to the rear side of the
main charger unit. Remove the electrode.
c. Stick the electrode cleaner to the tips of the electrode for cleaning
two or three times.
Note:
•
Do not move the cleaner with the electrode tips stuck
into the cleaner.
•
Cleaning should be evenly on the whole area, but not
partly.
d. Install the electrode on the document position and secure with the
screw.
e. Slide the main charger unit along the copier guide securely to
stop.
Rear side
CL spring
Front side
CL spring
Fixing screw
Fusing cover
Fusing unit
Front cabinet band
Paper exit area
Fixing angle
Fixing screw
Front cabinet
Fusing unit
Fixing angle
Positioning pin
Guide pin
Main charger unit
Fixing screw
Electrode
Main charger unit
Electrode cleaner
Electrode
Main charger unit
5 – 7
