Configuring the SDC 8200 system
99
language, the red signal light ring
and the “Microphone active”
LED
on their consoles light up.
y
Choose “
Override
” if activating an interpreter console in another
booth turns off the currently active interpreter console. The
interpreter console that was just turned off can only be turned on
again if the interpreter console by which it was turned off is
deactivated.
y
Choose “
Toggle Override
” if activating an interpreter console in
another booth turns off the currently active interpreter console. The
interpreter console that was just turned off can be turned on again
any time by pressing the MIC key
.
왘
Press the ENTER key to save your setting.
Configuring the operating mode within a booth
To determine whether or not the interpreter consoles installed within a
booth can be simultaneously active:
왘
From the central unit’s operating menu, choose “
Interpretation
”,
“
Options
” and “
Mode in Booths
” one after the other.
The current mode in shown on the display.
왘
Choose the desired mode.
You can choose between the modes “
Mixed
” and “
Toggle Override
”.
y
Choose “
Mixed
” if several interpreters in the same booth interpret
into the same language. When two interpreters simultaneously
interpret into the same language, the red signal light ring
and the
“Microphone active” LED
on their consoles light up.
y
Choose “
Toggle Override
” if activating another interpreter console
within a booth turns off the currently active interpreter console. The
interpreter console that was just turned off can be turned on again
any time by pressing the MIC key
.
Configuring the language options for the interpreter booths
The “
Configuration
” menu item on the “
Interpretation
” menu allows
you to configure the language options for the interpreter booths:
y
the main target language (A-channel)
y
the second target language (B-channel)
y
the auto-relay interpretation for the interpreters (auto-floor)
왘
After having configured the language options as described in the
following sections, press the EXIT key to get to the display shown on
the left.
왘
Press the ENTER key to save your configuration and to exit the “
Booth
Configuration
” menu.
Options
4
Mode in Booths
Mode in Booths
Mode = Mixed
Press ENTER to Save
Interpretation
1
Configuration
Save Config.
Yes
Press ENTER to Save