Configuring the SDC 8200 system
107
Adjusting the volume differences between the Aux Out 1 outputs
The volume of the AUX OUT 1 output available at the XLR-3M socket
differs from the volume of the AUX OUT 1 output available at the 15-pole
sub-D socket
. If you switch between the two outputs during a
conference, the volume can vary.
Attention! High Volume!
This is a professional conference system. Commercial use is subject to
the rules and regulations of the trade association responsible.
Sennheiser, as the manufacturer, is therefore obliged to expressly point
out possible health risks arising from use.
This system is capable of producing sound pressure exceeding
85 dB(A). 85 dB(A) is the sound pressure corresponding to the
maximum permissible volume which is by law (in some countries)
allowed to affect your hearing for the duration of a working day. It is
used as a basis according to the specifications of industrial medicine.
Higher volumes or longer durations can damage your hearing. At
higher volumes, the duration must be shortened in order to prevent
damage. The following are sure signs that you have been subjected to
excessive noise for too long a time:
y
You can hear ringing or whistling sounds in your ears.
y
You have the impression (even for a short time only) that you can no
longer hear high notes.
To adjust the volume difference between the XLR-3M socket and the 15-
pole sub-D socket:
왘
From the central unit’s operating menu, choose “
Aux-In/Out
” and
“
Aux Out 1
” one after the other.
왘
Choose “
Volume XLR
”.
The current volume is shown on the display.
왘
Reduce the volume and press the ENTER key to save your setting.
Assigning a channel to an audio output
Each of the audio outputs AUX OUT 2, AUX OUT 3, AUX OUT 4, AUX OUT 5
and AUX OUT 6 can be assigned a channel. The maximum number of
channels available depends on your license. The configuration of four
channels/languages is license-free. In order to be able to configure more
than four channels/languages (SDC 8200 CU only), you have to purchase
one of the language licenses available.
Note!
The floor channel is always assigned to the audio output AUX OUT 1.
This assignment cannot be changed!
To assign a channel:
왘
From the central unit’s operating menu, choose “
Aux-In/Out
”.
왘
Choose one of the audio outputs AUX OUT 2 to AUX OUT 6.
Aux Out 1
2
Volume XLR
Aux Out 1
Volume XLR = 24
Press ENTER to Save
