Setting up the SDC 8200 system
57
Setting up remote conferences
Instead of connecting an external audio source to the audio input of your
conference system, you can connect the audio output of a conference
system installed in a separate room to carry out a remote conference. The
participants of both conferences can then participate in a common
conference.
To connect two conference systems installed in separate rooms, you
require two XLR cables with two XLR-3 connectors respectively:
왘
Connect the audio input AUX IN 1
of the first central unit to the audio
output AUX OUT 1
of the secend central unit.
왘
Connect the audio input AUX IN 1
of the secend central unit to the
audio output AUX OUT 1
of the first central unit.
왘
From the central unit’s operating menu, choose “
Dist. Conf.
=
ON
” to
prevent echo (see “Configuring the audio outputs for remote
conferencing” on page 109).
Connecting PA systems, recording units, etc.
Via the audio outputs you can connect e.g. a PA system, a recording unit,
etc.
Connect the desired unit as follows:
왘
The signals of the floor channel are available at the XLR-3M audio
output AUX OUT 1
and the 15-pole sub-D socket AUX OUT 2
.
왘
The signals of up to four interpretation channels are available at the
outputs AUX OUT 2-3-4-5-6
of the 15-pole sub-D socket.
왘
If an SDC 8200 AO analog output unit is connected to the DATA OUT
socket
of
the SDC 8200 CU central unit, additional channels can be
output via the analog output unit’s XLR-3M audio outputs.
Pin assignment of the 15-pole sub-D socket (AUX OUT 2-3-4-5-6)
When connecting external equipment to the 15-pole sub-D socket (AUX
OUT 2-3-4-5-6
), please observe the following pin assignment:
PIN
SIGNAL
1+9
Aux Out 1
2+10
Aux Out 2
3+11
Aux Out 3
4+12
Aux Out 4
5+13
Aux Out 5
6+14
Aux Out 6
7
not assigned
8
not assigned
15
not assigned
The audio signal of the floor channel is always available at the two outputs
AUX OUT 1 (XLR-3M audio output) and AUX OUT 2 (pin 2 and 10 of the 15-
pole sub-D socket). This assignment cannot be changed!
