![background image](http://html1.mh-extra.com/html/sennheiser/sdc8200/sdc8200_system-manual_1240109105.webp)
Configuring the SDC 8200 system
105
To load the factory-preset default configuration for the interpretation
system:
왘
From the central unit’s operating menu, choose “
Interpretation
”,
“
Initialise Units
” and “
Load Default
s” one after the other.
The text “
Configuration will be overwritten. Continue?
” is
shown on the display.
왘
Press the ENTER key to replace your current configuration by the
factory-preset default configuration.
Resetting the interpretation system
You should reset the interpretation system each time you have made
changes to the configuration of the interpretation system via the central
unit. Resetting the interpretation system has no effect on the conference
system, i.e. you can make changes to the configuration of your
interpreation system even during a conference.
To reset the interpretation system:
왘
From the central unit’s operating menu, choose “
Interpretation
”
and “
Reset
” one after the other.
왘
Press the ENTER key.
The interpretation system is reset and the saved configuration
becomes effective.
Configuring the audio inputs and outputs
You can connect external audio sources such as a CD player, a microphone
with preamplifier etc. to the central unit’s audio inputs.
Instead of connecting an external audio source, you can connect the audio
output of a conference system installed in a separate room to carry out a
remote conference.
Via the audio outputs, you can connect e.g. a recording unit.
Via the “
Aux-In/Out
” menu, you can configure the central unit’s audio
inputs and outputs for the connected equipment.
Choosing the audio inputs and outputs
The central unit features six audio outputs.
The output signal of the floor channel is always available at the output
AUX OUT 1. The output AUX OUT 1 is available at the XLR-3M socket
and
the 15-pole sub-D socket
(for the pin assignment of this socket, please
refer to page 57).
The outputs AUX OUT 2 - 3 - 4 - 5 - 6 are available at the 15-pole sub-D
socket
(for the pin assignment of this socket, please refer to page 57).
The two inputs AUX IN 1 and AUX IN 2 are available at the two XLR-3F
sockets
and
.
Interpretation
2
Initialise Units
Initialise Units
1
Load Defaults
Interpretation
3
Reset
Reset
Press ENTER to
perform Reset