Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
22 /
122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
1.10 CONFIGURATIONS
The system is configured according to:
type of adjustment;
number of pumps.
The following table shows the configurations envisaged for the system.
Possible
configurations
Adjustment
Number of pumps
Configuration 1
Pressure
From 2 to 6
Configuration 2
Capacity
Configuration 3
Level with floats (lift from tank)
Configuration 4
Level with floats (tank filling)
Configuration 5
Level with probe (lift from tank)
Configuration 6
Level with probe (tank filling)
Configuration 7
Level with probe and floats (lift from tank)
Configuration 8
Level with probe and floats (tank filling)
Tab. 24
System configuration
Each system configuration includes:
electrical connections, for the hardware part;
HMI configuration, for the software part;
For the hardware configuration, please refer to
“1.1.2 Instructions for electrical connections” on
page 26
.
For the software configuration, please refer to
“1.3 HMI Configuration” on page 47
.
1.11 RESIDUAL RISKS
SENECA s.r.l. is not liable for any damages deriving from:
installation/use other than those envisaged and, in particular, other than the safety prescriptions provided for
by the regulations in force in the country where the product is installed and/or indicated in this Manual;
tampering and/or alteration of the product;
product configuration incorrect or not compatible with the type of application for which it is intended.
SENECA s.r.l. declines all responsibility for damage to persons and/or property deriving from the
incorrect configuration of the product.
An incorrect configuration of the product might cause risks for people and damage to the product itself. It is
mandatory
to always perform a product test after completing the configuration.
Summary of Contents for S6001
Page 1: ...ORIGINAL INSTRUCTIONS USER MANUAL S6001 Pump controller...
Page 2: ......
