Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
72 /
122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
1.1.7.1 “Set point” screen
54
56
55
Fig. 58 “Set point” screen
54
Display and base Set Point entry field. Press on the field to enter, using the keypad, the value
of the desired base Set Point.
55
Display and first adjustment Set Point entry field. Press on the field to enter, using the keypad,
the desired first adjustment Set Point value.
56
Display and second adjustment Set Point entry field. Press on the field to enter, using the
keypad, the value of the desired second adjustment Set Point.
Tab. 57 “Set point” screen
The base Set Point is the value that the process variable must reach and maintain over time. The
Set Point is not used for the “level control” application, since the operation of the pumps is controlled
by threshold exceeding levels.
The first adjustment Set Point has the same meaning as the base Set Point and intervenes only if it
has been enabled by the user. If it was set via “Digital input variation”, set the corresponding digital
input (refer to
“1.1.8.2 “IO digital type” screen” on page 78
).
The second adjustment Set Point has the same meaning as the base Set Point and intervenes only if
it has been enabled by the user. If it was set via “Digital input variation”, set the corresponding digital
input (refer to
“1.1.8.2 “IO digital type” screen” on page 78
).
Summary of Contents for S6001
Page 1: ...ORIGINAL INSTRUCTIONS USER MANUAL S6001 Pump controller...
Page 2: ......
