Seneca S6001, User Manual

Page: 113 / 122

Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
113 / 122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
6 6 SYSTEM UPDATE
The system update requires the software update of:
ƒ
RTU,
ƒ
HMI
via USB stick, on which the update file must be saved.
The update is available from http://www.seneca.it/prodotti/s6001-pump-controller
1.1 RTU SOFTWARE UPDATE
To Update the RTU software, carry out the following operations in the given order:
1. cut off the supply to the system;
24. insert the USB stick, containing the update, into the port (P5 - Fig. 2 on page 12) ;
25. apply the voltage stated in “1.9.2.1 RTU electrical technical characteristics” on page 17
to access the system;
26. at the end of the start-up (identified by the flashing “RUN” LED), wait for at least one minute;
27. remove the USB stick;
28. cut off the supply to the system.
1.1 HMI SOFTWARE UPDATE
To update the HMI software, carry out the following operations in the given order:
1. access the “HMI 1 properties” screen in “1.1.8.4 “HMI properties” screen” on page 85 ;
29. press key (88 - Fig. 70 on page 85) to start the update procedure;
30. when the “USB 1 update” sub-screen is displayed (Fig. 82 on page 114) , insert the USB stick
containing the update into port (P3 - Fig. 3 on page 14) ;