Doc. MI004620-I
S6001 Pump controller
Rev. 0
www.seneca.it
47 /
122
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION CAN
BE REPRODUCED WITHOUT PREVIOUS AUTHORIZATION.
User Manual
Port
Reference
Use
RS485
(P2 -
Fig. 2 on page 12)
Not used
RS485
(P3 -
Fig. 2 on page 12)
- For Z-D-IO expansion modules
(pumps 4, 5, 6 if provided)
- For inverter (if connected in mod
-
bus)
RS232
(P4 -
Fig. 2 on page 12)
Not used
RS232/RS485/RS422
(P1 -
Fig. 3 on page 14)
Not used
Tab. 45 Serial port connections
1.3
HMI CONFIGURATION
When first switching on, the HMI configuration must be performed. A wizard for system software configuration is
automatically started on the HMI.
Carry out the following operations in the given order:
1.
turn on the system referring to
“1.2.1 System start” on page 93
;
11.
run the HMI configuration as follows:
if the system is intended for the “pressure/flow regulation” application, refer to
“1.3.1 Pressure/flow
configuration wizard” on page 47
;
if the system is intended for “level control” applications, refer to
““1.3.2 Level configuration wizard” on page 52
.
The software configuration of the system MUST be compatible with the electrical connections made.
Refer to
“1.1 Electrical connections” on page 25
.
In case of subsequent changes to the electrical connections or to the devices connected to the system
(pumps, inverters, etc.), the software configuration must be executed again. Use the command in
section
“4.1.8.1 Confirm system reset” on page 73
It is forbidden
to use any type of tools (screwdrivers, etc.) to activate the HMI touch-screen.
1.3.1
Pressure/flow configuration wizard
Follow the wizard steps to configure the system. Find below the screens displayed sequentially by the wizard.
When the HMI is first switched on, user login is required. Refer to
“4.1.1 Login page” on page 56
Summary of Contents for S6001
Page 1: ...ORIGINAL INSTRUCTIONS USER MANUAL S6001 Pump controller...
Page 2: ......
