SCOV SV800 Series, User Manual

Page: 239 / 245

SV800/SV800A User Manual Appendix D: A1 application selection and parameter mapping
231
No. Name Factory default Description Mapping
parameter
Function selection detailed description of
Chapter 7.
A1-11 Torque boost Determined with the
model
Only valid for VF control
d4-01
A1-12 Start mode selection 1: Start from Min.
frequency start (E0-03)
0: Start by speed tracking
<2>
d4-04
A1-13 Stop mode 1: Deceleration stop 0: Free stop d2-06
A1-14 Upper limit frequency 50.00Hz Set according to
requirements
E0-00
A1-15 Low limit frequency 0.00Hz E0-01
A1-16 Max. frequency 50.00Hz E0-02
A1-17 Jog run command input 0: Keyboard control 1: Terminal control
2: Communication control
d1-06
A1-18 Jog frequency 0.80Hz E1-16
A1-19 DI3 function 1: Forward jog operation Refer to Chapter 7 for
details.
H0-02
A1-20 DI4 function 20: Fault reset Refer to Chapter 7 for
details.
H0-03
A1-21 AI1 signal type 0:0~10V 1:4~20mA (S2 switch needs
to be set to current side)
H2-00
A1-22 AO1 function 3: Inverter output
frequency
Refer to Chapter 7 for
details.
H3-00
A1-23 Prohibit Reversal Mode
Selection
0: OFF 2: Prohibit reverse running
d2-11
A1-24 Anti-Regeneration stall
function Selection
0: OFF 1: ON
d2-13
A1-25 Motor overload
protection
100% <3>
P0-03
A1-26~
A1-49
Retain
<1> V/F control can be used for general speed control applications. If high-performance speed control of
asynchronous motors is required, it can be set to 0: SVC vector control.
<2> d4-04 is effective only for V/F control, and vector control is the speed tracking start.
<3> Factory default is 1.5 times the motor rated current (b1-02) for one minute.