Ryobi RLT26CDY, User Manual, Page: 21 / 248

19
English (Original instructions)
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
Engine does not reach
full speed and emits
excessive smoke.
1. Check oil fuel mixture.
2. Air filter is dirty.
3. Spark arrestor screen is
dirty.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter. Refer to
Cleaning the Air Filter
earlier in this manual.
3. Contact a servicing dealer.
Engine starts, runs,
and accelerates but will
not idle. Idle speed screw on
carburetor requires
adjustment
Contact servicing dealer if the problem persists.
Line will not advance. 1. Line welded to itself.
2. Not enough line on spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
1. Lubricate with silicone spray.
2. Install more line. Refer to “Line Replacement” earlier
in this manual.
3. Pull lines while alternately pressing down on and
releasing bump head.
4. Remove line from spool and rewind. Refer to “Line
Replacement” earlier in this manual.
5. Advance line at full throttle.
Grass wraps round
shaft
h o u s i n g a n d b u m p
head. 1. Cutting tall grass at ground
level.
2. Operating trimmer at part
throttle.
1. Cut tall grass from the top down.
2. Operate trimmer at full throttle.
Bump knob hard to turn.
Screws threads dirty or
damaged. Clean threads and lubricate with grease - if no
improvement, replace bump knob.
Oil drips from silencer.
1. Operating trimmer at part
throttle.
2. Check oil/fuel mixture.
3. Air filter dirty.
1. Operate trimmer at full throttle.
2. Use fresh fuel and the correct synthetic 2-stroke oil
mix.
3. Clean per instruction in Maintenance Section.