Ryobi RLT26CDY, User Manual, Page: 20 / 248

18
English (Original instructions)
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
„
Clean all foreign material from the trimmer. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
„
Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used up in other 2-stroke engine powered equipment.
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start. 1. Power switch is off.
2. No spark.
3. No fuel.
4. Engine is flooded.
5. Starter rope now harder to
pull than when new.
1. Make sure Switch is in the ON or "I" position
2. The spark plug may be damaged, remove it and
check for dirt and cracks. Replace with a new spark
plug.
3. Push primer bulb until bulb is full of fuel. If bulb
does not fill, primary fuel delivery system is blocked.
Contact a servicing dealer. If primer bulb fills, engine
may be flooded, proceed to next item.
4. Remove spark plug, turn unit so spark plug hole is
aimed at the ground. Set start lever to “ ” position
and pull starter cord 10 to 15 times. This will clear
excess fuel from engine. Remove any fuel which
splashed on the product. Clean and reinstall spark
plug. Clean up any spilled fuel and move at least
9m away before restarting. Pull starter three times
with with start lever at “
”. If engine does not start,
set start lever to “ ” position and repeat normal
starting procedure. If engine still fails to start, repeat
procedure with a new spark plug.
5. Contact a servicing dealer.
Engine starts but will
not idle long enough to
engage throttle
Temperature can effect engine
idle time and rpm.
Flip start lever to RUN “ ” position and pull starter
until engine starts.
Engine does not stop
when switch is turned
off
Electrical connection is loose/
unplugged
Set the start lever to CHOKE “ ” to stop the engine.
Immediately stop using the product. Check electrical
connection on the bottom of the trimmer and make
sure it is properly connected. Contact servicing dealer
if the problem persists.
Engine starts but will
not accelerate. Engine requires approximately
three minutes to warm up.
Allow engine to completely warm up. If engine does
not accelerate after three minutes, contact a servicing
dealer.
Engine starts but will
only run at high speed
at half choke.
Carburetor requires
adjustment.
Contact a servicing dealer.