RTW SurroundMonitor 11900 Series, Manual, Page: 293 / 376

EN-103 9 | Menu | 9.4 | Input/Output Routing: The Global Routing Settings
EN
SurroundMonitor 11900 Series
9.4.1 | Input Routing
After selecting the
Input Routing
button, a new menu area opens up, containing 7 tabs labeled
Key 1
to
Key 7
.
the Toolbar (window 1 of the display). The corresponding input
connector is displayed below the name of the active preset in
the Status Box (window 4).
NOTE - Even after switching to a new channel mode
on one of the seven
Key
menu pages, the settings for the old
mode on this individual
Key
page are „remembered“ by the
device. Therefore, as soon as the old mode is selected again,
all parameters will switch back to the settings defined for that
mode earlier.
Depending on the channel mode defined for any key, this me-
nu page can look quite different. For example, the
lext/Rext
Routing
section of the menu page will be only available when
channel modes 3.1 or 5.1 are selected. Also, the channels
These tabs represent the 7 Sub Presets available within the
global settings that can be switched easily using the 7 num-
bered keys or Toolbar buttons. This option makes it very easy
and fast to switch between individual channel modes, routings,
instruments and peakmeter setups without having to load
new factory or user presets. For example, after having defined
several Sub Presets, it is very easy to check all signal sources
connected to the device with the preferred instrument readily
configured on the screen. The active Sub Preset is always
shown on the input source select button in the left corner of
available in the
Metering Routing
section depend on the se-
lected mode. Please refer to the following screenshots to see
how the page looks like in each mode.