RTW SurroundMonitor 11900 Series, Manual, Page: 208 / 376

5 | Start-Up EN-18 SurroundMonitor 11900 Series
nents as described before.
• according to en 61010 stan-
dard an additional earth conductor is
required, if the unit is mounted into
19’’ racks.
• Then connect the power with an earthed
3-wire power supply cord.
Never operate the unit without a properly
earthed power supply cord!
• Switch on the power. The Surround Monitor 11900
units will initiate its system startup sequence. This takes
around 50 seconds in which the TCP/IP and the net-
mask addresses are shown in the lower right edge of the
display. After this sequence the unit is ready for use.
ATTENTION! – Note the following instructions:
• Study and understand the safety instructions and the
information about connection.
• Make sure that the power supply cord is not connected
and the power switch on the rear panel is in the OFF
position.
• Connect the optional Remote Display 30010 unit to the
VGA Out connector on the rear panel of the main unit
using the VGA connection cable included with the display.
Alternatively you can connect a standard VGA monitor to
the same output, using a standard VGA connec tion cable.
The VGA cable shall be of 10 to 15 m maximum length.
• Connect all your other components to the appropriate
connectors on the SurroundMonitor 11900 units, using
the connection cables you have prepared for the compo-
The SurroundMonitor 11900 main units have been designed
to be installed in 19” rack systems. The instruments are ope-
rated with the function key control panel on the front side. An
external VGA monitor is needed for operation. The optional
8.4“ Remote Display 30010 available from RTW is matching
the colour and design of the main unit. All necessary power
supply voltages are supplied by the integrated wide voltage
power supply unit. The optional Remote Display 30010 unit is powered by an ex-
ternal 24 V DC power supply unit. A 5-meter VGA connection
cable (Bürklin type 13M4240) is included with the display unit.
If you need to purchase a replacement VGA connection cable
for the Remote Display 30010 please make sure that all the
pins of the connectors are wired as shown.
The other ports and interfaces are connected with the approp-
riate standard connection cables.
Please take care about the respectively proper pin assignment.
5 | Start-Up