RTW SurroundMonitor 11900 Series, Manual, Page: 272 / 376

8 | Instruments (Display Modes) | 8.13 | The DOLBY® META DATA Instrument EN-82 SurroundMonitor 11900 Series
8.13 | The DOLBY® META DATA Instrument
The
DOLBY® META DATA
instrument is always displayed in
window 3. To set the focus on this instrument (indicated by a
highlighted frame around the window), simply press the
inSTR
key. With the focus on window 3, the DOLBY® META DATA
functions are displayed in the Toolbar (window 1).
The Dolby® E and Dolby® AC-3 decoder is used for the
direct access to coded data streams for analyzing and control-
ling purposes without the need for external decoding.
If installed and activated (only included in the D and SD ver-
sions), the Dolby® Meta Data display shows the status of the
Dolby® E or Dolby® AC-3 signal and the status of the de
-
coder. It also displays the decoded meta data of the received
bitstream in plain text.
First page of the Dolby® meta
data display
8.13.1 | Activating the Decoder and changing parameters
If you want to use the Dolby® E and Dolby® AC-3 decoder you have to activate the decoder in the
Input/Output Routing
menus.
Please proceed as follows to access these menus from normal display operation:
1. Connect the coded signal to the BNC connector marked
with
in
on the rear side of the units.
2. Select
Menu
. The unit changes to menu mode.
3. Select the
Edit selected preset
button.
4. Select the
Local Input/Output Routing and Instrument
Settings menu tab. The local Routing Settings menu is
shown.
5. Select the
Input Routing
button.
6. Check the
Enable
option in the
decoder
section.
7. Define the decoder source and type using the correspon-
ding combo boxes.
8. In order to use decoded signals to be the source of other
inputs, select the
decoder
option in that input‘s
Source
combo box.
9. In order to change the assignment of the incoming signals
to the desired instrument channels as displayed, open the
channel combo boxes you want to change and select the
channel with the signal you want to assign to the selected
instrument channel.
10. Proceed until you have made all assignments and approp-
riate changes.
11. Select the
Save & Exit
button to store the changes and
leave the menu. The
Save Preset
menu page is displayed.
12. Select a User Preset of your choice to store your settings
in.
13. Select the
change name
button to edit the preset name.
A keyboard display is shown to enter a new preset name
(6 characters maximum).
14. Select the
Save & Exit
button again. All changes are
stored and the unit returns to normal operation.