ROYAL ENFIELD 650 TWIN SERVICE TRAINING MANUAL
157
ENGINE OIL PRESSURE CHECKING PROCEDURE
Procedure of Measuring the Engine oil pressure
check
1. Stand the vehicle on a level surface
2. Remove the NPT plug - Crankcase Lower LH side
3. Install the oil pressure adapter & pressure gauge
4. Check the engine oil level - Max condition
5. Start the engine and warm up the engine
6. Oil temperature to be checked from EOT sensor
7. Run the engine at the specified speed and wait till
the oil Temperature to reach in EOT at specified
limit and read the oil pressure gauge.
A) If the measured oil pressure is considerably
lower than the standard, inspect the oil pump
and the relief valve. if the oil pump and the
relief valve do not exhibit any abnormal
conditions, inspect the remaining areas of the
lubrication system.
B) If the measured oil pressure is considerably
higher than the standard, inspect the oil filter
and other areas of the lubrication system for
contamination or clogging .
Oil Pressure Standard :
Oil Pressure Value 4.5±0.5
Bar @4000RPM and 80°C at EOT sensor.
8. Stop the engine and remove the oil pressure
gauge and adapter.
9. Apply the liquid gasket (Refer TDL
T4200526
) to
the thread of the NPT plug and tighten it.
Oil Pressure Gauge
Oil Pressure Adapter
Oil Pressure Adapter & Gauge Assembled Condition
Oil pressure adapter
Summary of Contents for CONTINENTAL GT 650 TWIN 2018
