Royal Enfield CONTINENTAL GT 650 TWIN 2018, Service Training Manual

Page: 35 / 198

ROYAL ENFIELD 650 TWIN SERVICE TRAINING MANUAL
34
14. Frame

Remove engine mounting Top crankcase
and Bottom crankcase nuts from frame.
Use special tool 4 lug sockets to loosen
the special frame adjuster nuts top and
bottom before removing engine
mounting bolts with spacer tube on
frame.
15. Engine sub assembly

Gently side the engine assembly under
the frame and then finally disconnect
other electrical connections such as
Magneto coil & pulsar coil couplers,
Gear position sensor (GPS),
Side stand switch coupler,
Oil pressure switch (OPS) coupler and
RR Unit coupler.
Fastener, Size, Tool Usage, Precautions, Photos
13. LH & RH cradles

Remove the top and bottom allen bolts &
mounting engine front bolts on the LH
and RH cradle frames to the main frame at
the front, rear and centre after suitably
supporting the engine at the bottom.

Remove all the bolts & nuts mounting
engine to LH and RH cradle frames.
Aggregate to Dismantle Instructions
NOTE
Engine Mounting to Frame, follow the
reverse process of this chapter
dismounting from frame.
RH cradle frame
LH cradle frame
NOTE
Turn anti
clockwise
direction of
4 lugs checknut
with using
special tool to
unload on
engine.
Frame Adjuster
OD 14.8 x IDØ 10.8-
Engine
Part No: ST-30267/A
Frame Adjuster
ODØ 16.7 x IDØ 13 -
Engine
Part No: ST-30268/A