Fit B-3 connector and secure
with two S-2C bolts.
Continue building the end wall from the inside. Use the spacer with each panel and the two
remaining F-1 profiles. Repeat steps 3.2A through 3.2C.
NOTE: VIEWS ARE FROM OUTSIDE.
NOTE: VIEWS ARE FROM INSIDE.
IMPORTANT: The panels expand and contract depending on the temperature.
To ensure proper placement, use the 23 inch spacer included with the tools.
3.2A
3.2B
3.2C
3.2D
3.3
Working from inside, remove plastic film from both sides of one W-1 panel.
Fit panel into channel in base and corner profile, placing side marked
“ UV Resitant” facing outside.
B-3
S-2C
4
2
Connector
QTY
W-1
1
Panel
QTY
24” x 57”
B-3
S-2C
6
3
Connector
QTY
W-1
3
Panel
QTY
24” x 57”
NOTE: Panels will not fit completely to end of channels.
There will be some space to allow for temperature changes.
W-1
W-1
F-7
F-1
spacer tool
B-3
F-1
B-3
B-3
F-7
Place 23 inch spacer on base next to F-7 corner profile. Fit panel into
channel in F-1 profile and slide F-1 profile against spacer to ensure proper
placement. Position F-1 profiles so single set screw is next to base on inside.
15 of 46
WWW.RSIWW.COM
Add the last W-1 panel to complete the back. From the outside, fit F-7 corner profile into
place and secure with two B-3 connectors.
