IMPORTANT: Double check the position and
amount of unused set screws in the base. You
should have 53 available for later assembly.
IMPORTANT: One B-5 connector is installed on inside front.
Remaining B-5 connectors are installed on outside back
and sides. B-8 corner connectors are installed on inside.
Make certain side profiles are straight and flush. Adjust position of set screws in
inner bolt track at front of profile to fit holes in B-5 connector. Center connector
over seam for maximum hold. Secure using five bolts. Repeat on outer bolt
track to install nine remaining B-5 connectors at back and sides.
NOTE: Connector size is not shown
proportionally in this drawing.
Make certain corners line up and are flush. Adjust position of set screws in inner bolt track to fit
holes in B-8 connector. Secure with four bolts. Repeat until each corner is secure.
Measure base diagonally from inside corner. Equal measurements ensure the base is square. Use
a spirit level to make sure the base is level.
Locate predrilled holes in base profiles
and use six S-4 screws, one at each corner
and one in the center of each side to secure
to wood platform. You will secure the
greenhouse completely to the platform
in step 11.1 when assembly is finished.
1.4A
1.4B
1.5A
1.5B
S-2C 16
Connector
QTY
B-8
4
S-2C 50
Connector
QTY
B-5
10
B-5
B-8
B-8
B-8
B-8
B-8
B-5
B-5
B-5
B-5
B-5
B-5
B-5
B-5
B-5
B-5
S-4
6
Connector
QTY
S-4
B-8
9 of 46
WWW.RSIWW.COM
FRONT
BACK
