WWW.RSIWW.COM
36 of 46
Hold two profiles together at ridge using
one B-4 connector. Secure with two bolts.
Continue working from back to finish section three.
Remove plastic film from both sides of one W-1
panel. With side marked “ UV Resistant”
facing outside, install the next panel
on the right at the back. Push
panel into roof ridge channel
until the other end rests on
gutter ledge and then slide
towards F-1 profile at back.
Repeat to install W-1 panel
on left.
8.5D
8.5E
8.5F
From inside, fit one F-1 profile
with two set screws facing inside next
to panel. Hold in place with one B-4
connector on right side. Secure with
two bolts. Repeat to install F-1 profile
on opposite side.
B-4
S-2C
6
3
Connector
QTY
W-1
2
Panel
QTY
24” x 57”
W-1
W-1
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEW FROM OUTSIDE.
Remove next bungee cord and continue working from
back to install section four. Remove plastic film
from both sides of one W-1 panel. With
side marked “ UV Resistant” facing
outside, install the next panel
on the left at the back. Push
panel into roof ridge channel
until the other end rests on
gutter ledge and then slide
towards F-1 profile at back.
8.6B
8.6A
S-2C
2
Connector
QTY
W-1
1
Panel
QTY
24” x 57”
NOTE: VIEW FROM INSIDE.
NOTE: VIEW FROM OUTSIDE.
From inside, fit one F-1 profile with three set screws next to panel. Position profile so set
screws face inside and middle set screw is closer to top. Fit other end into B-4 connector
and secure with one bolt.
Repeat to install F-1 profile
on opposite side.
W-1
B-4
F-1
F-1
B-4
F-1
R-1
F-1
F-1
B-4