Prepare two F-3 profiles. Slide set screws into both bolt tracks on straight end of
F-3 profiles. Tighten each set screw to hold in place.
F-3
F-3
Assemble Back Wall
Prepare one F-2 profile. Slide set screws into both bolt tracks on each end of profile.
Tighten each set screw to hold in place.
F-2
6.1A
6.1B
6.1C
Connector
QTY
S-2A
S-2B
16
16
QTY
Profile
2
F-3
F-7
F-2
56”
15
⅞”
31”
1
2
WARNING: The cut edge of F-3 profile is
sharp. Use extreme caution when handling.
F-7
F-7
Prepare two F-7 corner profiles. Slide set screws into the same bolt track, one on each
end of profile. Tighten each set screw to hold in place.
WWW.RSIWW.COM
27 of 46
NOTE: Have the hex shaped indent facing up. Screw in until it is flush with bottom of nut so
it slides easily into bolt tracks. After inserting into bolt track, screw in until it holds in place.
Make certain the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
Prepare needed set screws as shown in step 1.1A
