Assemble Back Wall
3.1A
WWW.RSIWW.COM
14 of 46
NOTE: Have the hex shaped indent facing up. Screw in until it is flush with bottom of nut so
it slides easily into bolt tracks. After inserting into bolt track, screw in until it holds in place.
Make certain the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
Prepare needed set screws as shown in step 1.1A
Prepare two F-6 profiles. Slide set screws
into both bolt tracks on each end of two
F-6 mitered profiles. Hand tighten
each set screw to hold in place.
Prepare two F-10 profiles. Slide set screws
into both bolt tracks on each end of two
F-10 profiles. Hand tighten each set screw
to hold in place.
F-6
F-6
F-10
F-10
NOTE: Set screw in center bolt channel is used when installing optional
shelving units. Install F-7 profile with set screw near base until needed.
Prepare one F-7 corner profile. Slide set screws into all three bolt tracks
on one end and into two side bolt tracks on other end of corner
profile. Hand tighten each set screw to hold in place.
F-7
Prepare three F-1 wall profiles. Slide set screws into both bolt tracks on one end of profile and
one bolt track on the other end. The single set screw will
sit on the inside near the base when installed.
Hand tighten each set screw to
hold in place.
F-1
F-1
F-1
3.1B
3.1C
3.1D
S-2A
S-2B
30
30
QTY
Profile
56”
56”
1
F-7
F-1
3
QTY
Profile
2
F-6
F-10
2
23”
23”
