Make certain the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
Install Roof Vents
NOTE: You will use the Gripping Channels in next steps. You do
not need the other included parts in Window Opener package.
Unpack contents of Automatic Window Opener. Screw adjusting
knob partially into threaded end of cylinder. Do NOT tighten.
Fit piston rod connected to arm B into
end of cylinder. Turn cylinder so holes
next to adjusting knob are visible.
Continue pushing cylinder onto piston rod until holes
in end of cylinder line up with holes in arm A. Push
arms apart if necessary. Secure with
a threaded stud on each side.
Turn adjusting screw clockwise
until arms are aproximately
6” apart.
Repeat steps 9.1A through 9.1D
to prepare three more
Automatic Window Openers.
adjusting knob
cylinder
piston rod
cylinder
arm B
QTY
Threaded Stud
8
QTY
Adjusting Knob
4
QTY
4
Cylinder
QTY
4
Handle
arm A
9.1A
9.1B
9.1C
9.1E
9.1D
9.2A
9.2B
Remove plastic film from both sides of V-2
factory assembled vents. With side labled
“ Face inside” facing up, lay panel
on flat clean surface.
Measure and
mark center
of vent.
V-2
4
Factory Assembled Vent
QTY
24”
x
24
¾”
V-2
V-2
arm A
Place opener with arm A on bottom
inside vent. Mark screw placement.
Using S-1 screw, apply pressure to
puncture the panel and predrill
holes for next step.
S-1
WWW.RSIWW.COM
41 of 46