Prepare eight F-1 profiles to be used with braces. Slide two set screws into bolt track on one
end and one set screw on the other end of profile.
Assemble Roof
Measure 19
5⁄8 inches from one side of profile. Slide middle set screw to that point and tighten
to hold in place. Tighten the other two set screws on each end of profile.
8.1A
8.1B
8.1C
QTY
Profile
56”
F-1
18
S-2A
S-2B
44
44
Prepare all profiles for roof. Prepare ten F-1 profiles. Slide one set screw
into bolt track on each end of profile. Tighten to hold in place.
F-1
F-1
F-1
F-1
F-1
F-1
F-1
F-1
F-1
F-1
19
5⁄8
”
(498mm)
F-1
F-1
F-1
F-1
F-1
F-1
F-1
WWW.RSIWW.COM
32 of 46
NOTE: Have the hex shaped indent facing up. Screw in until it is flush with bottom of nut so
it slides easily into bolt tracks. After inserting into bolt track, screw in until it holds in place.
Make certain the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
Prepare needed set screws as shown in step 1.1A
F-1
