5.9A
5.9B
5.9C
5.9D
Prepare two F-7 corner profiles. Slide three set screws into the same
bolt track, two on one end and one on other end
of profile. Position one set screw in center of
profile. It will be used in a later step.
Tighten each set screw to
hold in place.
NOTE: VIEW FROM OUTSIDE.
NOTE: VIEW FROM INSIDE.
F-7
F-7
Use C-1 connector to secure each outside corner. Loosen set
screws on profiles and adjust position to fit holes in C-1 connectors.
Make sure all profiles line up flush against each other. Secure with bolts. Repeat on other side.
Check inside corners to ensure B-7 connector is still in
proper position. If it needs adjusting, repeat steps 5.8
and 5.9C through 5.9D until
each corner is set.
S-2C
6
C-1
2
S-2A
S-2B
6
6
QTY
Profile
F-7
2
56”
NOTE: VIEW FROM OUTSIDE.
G-1
C-1
F-7
F-7
F-6
From outside fit F-7 profiles into each side of front. Begin with either side. Arrange F-7 profile
so channel lines up with tops of panels and the
set screws are facing out. The side of the
profile rests against cut angle of F-3
profile. The top end touches edge of
F-4 center profile and bottom end
touches top of G-1 gutter.
Position both F-7 profiles.
F-3
F-7
G-1
G-1
F-7
F-3
F-4
26 of 46
WWW.RSIWW.COM
G-1
F-6
B-7
F-7
