![background image](http://html.mh-extra.com/html/rands/upv/upv_getting-started_3262652119.webp)
Getting Started
R&S
®
UPV
103
Getting Started 1146.2078.62 ─ 09
i)
The desired output voltage for the measurement is entered in the "Voltage"
field; once again, the field must be highlighted before the value can be entered.
The value range is again displayed above the softkeys and the available units
are shown in the softkeys.
The remaining fields are not relevant for this example. Configuration of the gen-
erator is therefore complete.
3. Step: Selection of required measurement
a) The basic settings for configuring the analyzer are made in the "Analyzer
Con-
fig" panel.
In order to operate the panel, it must be selected and have the focus.
The frequency response is usually measured on both channels; this is already
configured in the Channel field. The setting 2
≡
1 means that both channels
have the same settings; the following parameter fields appear once only in the
panel but affect both channels.
Introduction to Instrument Operation Using Examples