Startup
R&S
®
UPV
43
Getting Started 1146.2078.62 ─ 09
2. Select "Digital Display".
The external monitor is switched off.
Devices with FMR9
Special features with the FMR9:
The Windows XP operating system used is only able to support a maximum of two
monitors simultaneously. One of the two monitors is the internal LC display, which
means that only one external monitor can be controlled even if the R&S
UPV with
FMR9 has an analog VGA
and
a digital DVI port. The default setting assumes that the
internal monitor and one external analog VGA monitor will be used. The connected
external monitor determines the behavior during the boot procedure depending on the
selected setting under Windows: If an external analog VGA monitor is connected and
"No Monitor" has been selected under Windows, both screens will show the
same content during the boot procedure and when Windows is running. If a digital DVI
monitor is connected, the internal display will remain dark during the boot procedure
until Windows becomes active, regardless of its Windows setting. Only after this will
both displays show the same content in parallel if "No Digital Display" was
selected under Windows. Otherwise only the internal display becomes active under
Windows.
Setting the External Monitor Resolution to Higher than 800 x 600 Pixels
1. Switch off R&S UPV.
2. Connect the external monitor, keyboard and mouse.
3. Switch on R&S UPV.
4. After starting the R&S UPV, exit or minimize the UPV program by clicking on the
buttons on the right in the title bar.
5. Right-click on the desktop to open the following context menu.
Connecting an External Monitor