RADWAG UYA 4Y, User Manual

Page: 162 / 196

- 162 -
Play/ Pause playing
Stop playing
Increase/decrease the volume (volume power adjusted, for
settings go to
<Miscellaneous> parameters group).
Enabling/Disabling the volume
Restart video
38. COMMUNICATION PROTOCOL
General information
A. A character based communication protocol balance-terminal is designed for establishing
communication between a RADWAG balance and a peripheral device via RS-232C serial
interface.
B. It consists of commands sent from a peripheral device to the balance and responses from
the balance.
C. Responses are sent from the balance on each receipt of a command as a reaction to a
specific command.
D. Commands, forming the communication protocol, enable both, obtaining data on balance
status and influencing balance operation, e.g.: acquiring measurement results from the
balance, zeroing, etc.
38.1. LIST OF COMMANDS
Command Command overview
Z Zero balance
T Tare balance
OT Give tare value
UT Set tare
S Send stable measurement result in basic measuring unit
SI
Immediately send measurement result in basic measuring unit
SIA Immediately give results from all platforms in basic measuring units
SU Send stable measurement result in current measuring unit
SUI
Immediately send measurement result in current measuring unit
C1
Switch on continuous transmission in basic measuring unit
C0
Switch off continuous transmission in basic measuring unit
CU1 Switch on continuous transmission in current measuring unit
CU0
Switch off continuous transmission in current measuring unit
DH Set min checkweighing threshold
UH Set max checkweighing threshold
ODH Give value of min checkweighing threshold