RADVision MCU-323, User Manual

Page: 31 / 185

2-1
Prepare the Site
!
Before installing the MCU-323 unit, prepare the following
"
LAN port or hub to connect to the MCU-323.
"
All necessary cables.
"
A grounded AC power outlet.
"
Clearance of at least 10 cm (4 inches) behind the unit for interface cable connections.
"
Environmental conditions consisting of an operating temperature between 0
°
and 40
°
C
(32
°
-104
°
F) and relative humidity between 15% and 85%, non-condensing.
Make Cable Connections
The following describes connecting the power and the LAN connection to the MCU-323.
Refer to
Overview for an illustration of the MCU-323 rear panel and its cable connections.
Connect the Power
The MCU-323 receives AC power through a standard power cable with a grounded three-
prong plug. The wiring scheme is as follows:
"
Brown lead Live (phase)
"
Blue lead Neutral
"
Green/yellow lead Earth ground
!
To connect power to the MCU-323
1. If your power cable was supplied without a plug, connect your local standard grounded
power plug according to the wiring scheme above.
2. Connect the molded IEC socket of the power cable to the MCU-323 power connector
at the right side of the rear panel.
3. Verify that the power On switch is in the Off (0) position.
4. Connect the three-prong power plug of the power cable to a grounded AC outlet.