RADVision MCU-323, User Manual

Page: 38 / 185

Preparing for Configuration
3-2
Selecting an MCU-323 for Configuration
The first step in configuration is selecting an MCU-323 device on the LAN that you want to
configure. When configuring more than one new unit, install and configure only one device
at a time.
Unit IP (text box/list box) — Displays the unit IP address and type of all detected devices
on the LAN.
Detect (button) — Click this button to restart the detection of devices on the local network
segment.
Remote Configuration — The remote configuration option is reserved for future use.
!
To select the OnLAN unit you want to configure
1. In the Select Unit screen, select the OnLAN device you want from the Unit IP list
box.
2. Click Next . The Enter Password screen is displayed.
3. Enter the password for the unit and click Next . The Configuration Source screen is
displayed.
Your next steps are to determine the
Unit Type , and configure either the built-in
Gatekeeper or the MCU-323.
Entering a New IP Address for a New MCU-323
If there are no other RADVision units on the LAN, the first time you configure the
MCU-323 the
Unit IP text box and list box both appear empty. This is because new
RADVision units have a default IP address not suited to your local network IP scheme. For
the configuration software to detect a new unit, you must assign an IP address according to
the IP addressing scheme of the network segment it is attached to.
You can change the IP address of a new unit from the Select Unit screen. Before you
change the IP address of a new unit make sure that:
"
The terminal running the configuration software resides on the same LAN segment as
the new unit, and the terminal IP address matches the IP address of the network segment
it is on.
"
The new MCU-323 is the only new RADVision unit on the network. Turn off all other
new RADVision units that don’t appear in the Select Unit screen before you proceed.