Chapter 4 On-board Remote Management
Diagnostics Page
Quantum SuperLoader 3 User’s Guide
63
Diagnostics
4
To view the various diagnostic options:
1
From any page, click the
Diagnostics
heading. The
Diagnostics
screen
displays.
2
In the
Diagnostics
section, select the diagnostic test that you want to
run from the
Test
drop-down menu.
3
Specify a loop count, if desired.
4
Click
Start Test
.
5
While the test is running, you can view the status of the test. From
View Diagnostic Test Progress
, click
View Status
.
A separate screen indicates which test is running and the current
status of the diagnostic test.
6
To refresh the status information, click
View Diagnostic Test Progress
,
and then click
View Status
again.
Identification
4
You can use the
Identification
feature of the autoloader by requesting the
LCD backlight to flash for a specified number of seconds.This can be
helpful in identifying the location of the autoloader in an equipment
room.
1
From any page, click the
Diagnostics
heading. The
Diagnostics
screen
displays.
2
Under
Identification
, enter the number of seconds in the
Time (secs)
field.
3
Click
Identify
. The LCD backlight flashes on the autoloader for the
specified number of seconds.
Performing a System
Reset
4
You will use
System Reset
when making SCSI ID changes, mode changes,
magazine changes, and IP address changes. A system reset will take at
least three minutes if there is a tape in the drive, or approximately 30
seconds otherwise. To perform a system reset:
1
From any page, click the
Diagnostics
heading. The
Diagnostics
screen
displays.
2
Under the
System Reset
section, click
System Reset
.