Chapter 2 Installation and Configuration
Installation Overview
Quantum SuperLoader 3 User’s Guide
7
Installation Overview
The SuperLoader 3 is a SCSI device that interfaces to your host computer
(see
SCSI Interface
).
A Fibre Channel version of the autoloader is available when equipped
with a LTO-3 or DLT-S4 native Fibre Channel tape drive (see
Fibre
Channel Interface
).
A Serial Attached SCSI (SAS) version of the autoloader is available when
equipped with a LTO-3 or LTO-4 SAS tape drive (see
SAS Interface
).
SCSI Interface
2
Installing the SCSI autoloader consists of the following steps, which are
explained in more detail later in this section:
1
Prepare to install your new Quantum SuperLoader 3 autoloader (see
“Choosing a Location”
on page 10).
2
Identify the proper SCSI bus types (see
“SCSI Bus Requirements”
on
page 12).
3
Identify the accessories that come with the autoloader (see
“Accessories”
on page 14).
4
Install the autoloader in a computer rack or select a table or desktop
near the host server. If installing a rack mount unit, refer to
“Rack
Mounting the Autoloader”
on page 93.
5
Shut down or turn off the server and all devices attached to the
server.
6
Attach the SCSI cable to the autoloader and server's SCSI host
adapter (see
“Connecting SCSI and Power Cables”
on page 18).
7
Attach the power cable to the autoloader and plug in the power cable
to the nearest power outlet (see
“Connecting SCSI and Power Cables”
on page 18). Power the autoloader on to ensure it passes the power
on self-test (POST).
8
Set the SCSI ID for the autoloader (see
“SCSI Autoloader”
on
page 70).
9
Set up the host and verify the connection (see
“Preparing the Host
and Verifying the Connection”
on page 23).