Chapter 5 Administration
Setting the Change Mode
Quantum SuperLoader 3 User’s Guide
77
• To modify the change mode, scroll to the mode to which you
want to set the autoloader and press
Enter
.
Reboot to enable new
mode
appears on the LCD.
4
Press and hold the power button on the front panel until
System
Shutdown wait 60 sec
appears on the LCD.
Power Off
appears on the
LCD and the autoloader shuts off.
5
Press the power button again to power up the autoloader. The new
change mode is now in effect.
Sequential Mode
Operations
5
If you enable
Sequential
mode, you must use the
Sequential Ops
submenu
under the
Commands
menu to operate the autoloader after you reboot.
• The
Start
command allows you to load the first cartridge.
• The
Resume
command allows you to continue from the next unused
slot, if a user stopped the cycle.
• The
Stop
command allows you to stop the cycle.
To start
Sequential
mode operation:
1
From the main menu, scroll to
Commands
, and then press
Enter
.
2
From the
Commands
menu, scroll to
Sequential Ops
, and then press
Enter
.
3
From the
Sequential Ops
menu, scroll to
Start
, and then press
Enter
.
Moving first tape to drive
appears on the LCD.
To stop
Sequential
mode operation:
1
From the main menu, scroll to
Commands
, and then press
Enter
.
2
From the
Commands
menu, scroll to
Sequential Ops
, and then press
Enter
.
3
From the
Sequential Ops
menu, scroll to
Stop
, and then press
Enter
.
Ejecting tape from drive
appears on the LCD.
To resume
Sequential
mode operation:
1
From the main menu, scroll to
Commands
, and then press
Enter
.
2
From the
Commands
menu, scroll to
Sequential Ops
, and then press
Enter
.
3
From the
Sequential Ops
menu, scroll to
Resume
, and then press
Enter
.
Moving next tape to drive
appears on the LCD.