10.
Use a 3/32-inch Allen wrench to remove all four Carousel Motor mounting screws
(Figure 7-37).
11.
Remove the Carousel Motor from the cabinet.
7.17.2 Carousel Motor Replacement
1.
Align the mounting holes in the Carousel Motor with the corresponding mount-
ing holes in the TLS’ Midplate, so that the motor’s cable faces the rear of the TLS
(Figure 7-37).
NOTE
For TLS models 4660 and 46120, the Carousel Motor is mounted in the right side of the cabinet
(as seen from the front). For all other TLS models, the Carousel Motor is mounted in the left side
of the cabinet.
2.
Use an 3/32-inch Allen wrench to install and securely tighten all four Carousel
Motor mounting screws.
3.
Reconnect the Carousel Motor cable to the Carousel PCBA (Figure 7-35).
4.
For TLS models 4660 and 46120, replace any nylon cable ties that were removed
earlier from the motor cable (Figure 7-38).
CAUTION
Be careful not to damage the Carousel Position Sensor with the Carousel Gear
Guard when you reinstall the Carousel (Figure 7-35).
5.
Align the lower Carousel Bearing with the TLS Midplate, then lower the Carou-
sel down into place (Figure 7-37). Be sure to align the Carousel Gear with the
gear on the Carousel Motor shaft as you lower the Carousel into position.
6.
Align the Upper Carousel Bearing with the Upper Carousel Pivot Support, then
lower the Upper Carousel Pivot Support down through the top of the TLS onto
the Upper Carousel Pivot (Figure 7-37).
7.
Align the mounting screw holes in the Upper Carousel Pivot Support with the
mounting screw holes in the TLS, then use a number 2 Phillips screwdriver to
install all three Upper Carousel Pivot Support mounting screws (Figure 7-36).
8.
Replace the right Side Panel (Section 7.4.4).
9.
Replace the Top Panel (Section 7.4.2).
7-60
Field–Replaceable Units (FRUs)
501380 Rev. B
