9.2.1.1.2
Adding the Carousel Midplate
Carousel Motor
Power Cable Connector
Midplate
Screw Holes (6)
Carousel Motor Cable
Front of TLS
Rear of TLS
Carousel PCBA
Carousel Motor
Carousel Motor
Power Cable Connector
Top View of
Carousel Midplate
Carousel Midplate
REAR VIEW
Figure 9-5 The Carousel Midplate with Motor and PCBA
1.
Place the Carousel Midplate in the TLS and align it with the six mounting holes
in the top of the drive bay sides. (Figure 9-5).
2.
With a Phillips screwdriver attach the Midplate to the top of the drive bay sides
using the Midplate and Receiver Assembly Mounting Plate screws that were re-
moved earlier.
3.
From the right and left sides of the TLS, use a Phillips screwdriver to install the
four Midplate screws that were removed earlier. (Figure 9-4).
4.
Attach one end of the CAROSL ribbon cable to the CAROSL connector on the
Executive PCBA. See Figure 7-28.
501380 Rev. B
TLS
Expansions
9-5
