3.
Position a second Nylon Cable Tie over the Switch Bracket Ribbon Cable, then
attach it to both ends of the Nylon Cable Tie in the Switch Bracket Assembly
(Figure 7-23).
4.
Tighten the Nylon Cable Ties,
without crimping the cable,
until they secure the
Switch Bracket Ribbon Cable to the Switch Bracket Assembly.
5.
Trim off the excess length of plastic from each Nylon Cable Tie.
6.
Starting behind the LCD, position one Nylon Cable Tie behind the Switch
Bracket Ribbon Cable and the Display Cable, then position a second Nylon Cable
Tie over the both cables, and attach the cable ties to each other (Figure 7-23).
7.
Tighten the cable ties,
without crimping the cables
, until they secure the Switch
Bracket Ribbon Cable to the Display Cable.
8.
Trim off the excess length of plastic from each Nylon Cable Tie.
9.
Starting above where the Display Cable connects to the PCBA, position one Ny-
lon Cable Tie behind the Switch Bracket Ribbon Cable and the Display Cable.
Next position a second Nylon Cable Tie over the both cables, and attach the cable
ties to each other (Figure 7-23).
10.
Tighten the cable ties,
without crimping the cables
, until they secure the Switch
Bracket Ribbon Cable to the Display Cable.
11.
Trim off the excess length of plastic from each Nylon Cable Tie.
12.
Remove all six mounting nuts from the Switch Bracket Assembly mounting
studs (Figure 7-22).
13.
If the spacers and the Spring Finger (if the unit has a Spring Finger) were re-
moved, mount the Spring Finger onto the right top mounting stud, then place
the two short spacers onto the top mounting studs. Place the four longer spacers
onto the four lower mounting studs (Figure 7-22).
14.
Slide the Switch Bracket Assembly onto the mounting studs (Figure 7-22).
15.
Thread all six mounting nuts onto the mounting studs, then use a 1/4-inch nut-
driver to tighten the mounting nuts until they are snug (Figure 7-22).
16.
Remove the slack in the ribbon cable, so that it doesn’t interfere with the car-
riage movement, by gently feeding any excess cable up through the opening in
the top plate.
501380 Rev. B
Field–Replaceable Units (FRUs)
7-35
