Barcode Reader Cable
Barcode Reader
Barcode Reader
Mounting Screws
Access Hole in rear of
Insertion Axis Motor
Gripper Assembly
Figure 7-11 Barcode Reader (TLS-180/360 Model Shown)
7.7.1 Barcode Reader Removal
NOTE
It is not necessary to remove the Carriage Assembly from the TLS before removing the Barcode
Reader.
1.
Turn off the TLS power and remove the power cord.
2.
Open the cabinet door.
3.
It may be necessary to manually lower or raise the Carriage Assembly, so that it
is approximately in the middle of its vertical range of motion. Grasp the Carriage
Assembly and gently lift it up, or push it down.
4.
Unplug the Barcode Reader cable from the back of the Barcode Reader.
5.
Insert a 9/64-inch Allen wrench into the Access Hole in the rear of the Insertion
Axis Motor.
6.
Gently turn the Allen wrench counter-clockwise to move the Gripper forward,
until both Barcode Reader mounting screws are accessible, then remove the
wrench.
7.
Place your hand under the Barcode Reader. Use a number 2 Phillips screwdriver
to remove both Barcode Reader mounting screws (6x32 by 1/4-inch Flathead
501380 Rev. B
Field–Replaceable Units (FRUs)
7-19