7.16.1 Carousel PCBA Removal
Carousel
Gear Guard
Carousel PCBA
Carousel Motor
Power Cable
Connector
CAROSL
Cable Connector
Carousel
Position Sensor
(Optical Switch Pair)
PCBA
Mounting Screws (3)
PCBA Alignment Pin
PCBA Spacer (3)
Figure 7-35 The Carousel PCBA (3 Views)
1.
Turn off the TLS power and remove the power cord.
2.
Open the cabinet door.
3.
Reach in through the cabinet door and disconnect CAROSL Cable and the Car-
ousel Motor Power Cable from the Carousel PCBA (Figure 7-35).
NOTE
If necessary, remove magazines and rotate the carousel slightly by hand to reach each PCBA
4.
Use a number 2 Phillips screwdriver to remove all three PCBA mounting screws
and PCBA spacers (Figure 7-35).
CAUTION
In the next step, be careful not to damage the Carousel Position Sensor on the
Carousel Gear Guard (Figure 7-35), as you remove the Carousel PCBA.
5.
Lift the Carousel PCBA slightly to clear the PCBA Alignment Pin, then gently
slide the PCBA along the Carousel Gear Guard toward the front, center of the
7-56
Field–Replaceable Units (FRUs)
501380 Rev. B
