Q2 Q2A, Technical Manual

Page: 724 / 866

12.7 H: TERMINALS
724 SIEPYEUOQ2A01G AC Drive Q2A Technical Manual
■
13: FreqDetect 1
Setting Value Function Description
13 FreqDetect 1
The terminal turns off when the output frequency is higher than the value of L4-01 [SpAgree Det.Level] + L4-02 [SpAgree Det.
Width] . After the terminal turns off, the terminal continues to remain off until the output frequency reaches the level set with
L4-01 .
Note:
•
The motor rotation direction does not have an effect on the detection function. The drive uses the L4-01 value as the forward/reverse
detection level.
• CLV control uses motor speed as the reference.
ON : The output frequency is less than the value of L4-01 or is not more than the value of L4-01 +
L4-02 .
OFF : The output frequency is higher than the value of L4-01 + L4-02 .
Figure 12.92 Frequency Detection 1 Time Chart
Note:
Figure 12.92 shows the result of the configuration when
L4-07 = 2 [SpAgree Det.Selection = Always Detect]
. The default setting of
L4-
07 is 1 [No Detect@BB] . When the speed agreement detection selection is “ No Detect@BB ” , the terminal is deactivated when the drive
output stops.
■
14: FreqDetect 2
Setting Function Description
14 FreqDetect 2
The terminal activates when the output frequency is higher than the setting value of L4-01 [SpAgree Det.Level] . After the
terminal activates, the terminal stays on until the output frequency is at the value of L4-01 - L4-02 .
Note:
• The motor rotation direction does not have an effect on the detection function. The drive uses the L4-01 value as the forward/reverse
detection level.
•
CLV control uses motor speed as the reference.
ON : The output frequency is higher than the value of L4-01 .
OFF : The output frequency is less than the value of “ L4-01 - L4-02 ”, or is less than the value of
L4-01 .
Figure 12.93 Frequency Detection 2 Time Chart
■
15: FreqDetect 3
Setting Function Description
15 FreqDetect 3
The terminal deactivates when the output frequency is higher than the setting value of “ L4-03 [SpAgree Det.Level(+/-)] + L4-04
[SpAgree Det.Width(+/-)]
”
. After the terminal deactivates, the terminal stays off until the output frequency is at the value of L4-
03 .
V/f CL-V/f OLV CLV AOLV OLV/PM OLV/PM AOLV/PM CLV/PM EZOLV
V/f CL-V/f OLV CLV AOLV OLV/PM OLV/PM AOLV/PM CLV/PM EZOLV
V/f CL-V/f OLV CLV AOLV OLV/PM OLV/PM AOLV/PM CLV/PM EZOLV