PCC IV Instruction Manual (rev. 0)
Page 4-1
Section 4
– Menu operations
Section 4: Menu Operations
Table of Contents
Introduction ............................................................... 2
Entering the Main Menu ............................................ 3
Menu Tree ................................................................. 3
Main Menu ................................................................ 4
Quick Parameters Menu ............................................ 4
Last Parameter ...................................................... 4
Service Manual Menu ................................................ 5
What is "Service Manual" (S/M) Mode? ................ 5
Entering Service Manual (S/M) .............................. 6
Set All Outputs to S/M ........................................... 6
Set All Outputs to Auto .......................................... 6
Change One Output to S/M or Auto ....................... 6
Changing an Output Value in S/M Mode ............... 6
Password Menu ........................................................ 7
Password Levels.................................................... 7
The Change Password Soft-button ....................... 7
Enabling the Password System ............................. 7
Disabling the Password System ............................ 8
Browse Blocks Menu ................................................. 8
General .................................................................. 8
How to use Browse Blocks .................................... 9
Navigation .............................................................. 9
Change a Parameter ............................................. 9
Forcing Block Outputs ........................................... 9
Utilities Menu ............................................................10
Set Clock Time/Date Menu ...................................10
Memory Menu ...................................................... 11
Save Config Changes: ......................................... 11
Calibrate I/O Menu ............................................... 11
When is Calibration Required? ............................. 11
Analog Input Calibration Procedure ...................... 12
Analog Output Calibration Procedure ................... 13
Screen Utilities Menu ........................................... 14
Calibrate Touch .................................................... 14
Clean Screen ........................................................ 14
Enable Buzzer ...................................................... 14
Choose Theme ..................................................... 15
Set Touch Sensitivity ............................................ 15
M4 Messages Menu ............................................ 15
Modbus Ports ........................................................... 15
RS485 Port .......................................................... 16
Device Address .................................................... 16
Baud Rate ............................................................ 16
Parity .................................................................... 16
RTU/ASCII ............................................................ 16
+/- Data ................................................................ 16
Ethernet Port 0 (or 1) ............................................ 16
IPv4 address ........................................................ 16
IPv4 mask ............................................................. 16
IPv4 gateway ........................................................ 17
Supported Modbus Functions ............................... 17
