Polycom MGC Administrator, Administrator'S Manual

Page: 84 / 584

Chapter 3 - Defining Network Services
3-34
2. Right-click the unit you want to configure. Depending on the card clock
source assignment (if primary or backup) the following options appear.
3. Click the desired option.
After setting the network clock, a Warning message box opens, advising
you to reset your MCU.
The configuration changes take effect only after the next MCU reset or
startup, and are shown in the
Configured Clock column in the Status
pane.
Table 3-7: Network Interface Unit (ISDN) - Configuration Options
Option Description
Set as Primary
Clock Source Sets this unit as the primary clock source. For further
information, see Chapter 5, “Clocking” on
page 5-132.
Cancel Primary
Clock Source Stops this unit from acting as the primary clock
source. For further information, see Chapter 5,
“Clocking” on page 5-132.
Set As Backup
Clock Source Sets this unit as the backup clock source. For further
information, see Chapter 5, “Clocking” on
page 5-132.
Cancel Backup
Clock Source Stops this unit from acting as the backup clock
source. For further information, see Chapter 5,
“Clocking” on page 5-132.