PMA KS 98, Manual

Page: 156 / 246

Digital programmer operating page
Digital programmer DPROG has an operating page, which can be selected in the
operating page menu with input ‘
hide
‘ not connected. For changing the value
of an entry field, this value must be marked using
ID
(inverse display). When
acknowledging the value with
M
, it starts blinking and can be adjusted with
ID
. When reaching the required value, it must be acknowledged with
M
. If the
FB inputs assigned to the input fields (function block inputs) in the following table
are allocated to the engineering, operation (change) of this input field is not possi-
ble.
Input fields Operation Display FB input
Rec
If input ProgNo is wired, entering of the
desired recipe number is not possible over
the frontside! indicates the actual recipe number.
ProgNo
Seg
If control input preset is wired, entering the
desired segmentnumber is not possible over
the frontside! indicates the actual segment number
preset
Ü
No operation possible Status of control outputs (do1...do6) in the
actual segment
tNetto
Entry of required programmer time (preset
to time) indicates the total
run
time (without
pause)
preset
tRest
No operation possible indicates the time until program end.
Status
stop
Stopping the programmer the programmer was stopped
run
run
Starting the programmer the programmer was started
reset
The programmer is switched to segment 0
and ’
stop
‘
the programmer is switched to segment 0
and’
stop
‘
reset
quit
Leaving the field without change
Distinction of preset (to segment 1) and reset
D0 is output with reset. With preset to segment 1, however, D1 is output, although both actions are realized at time
t=0.
Programmer
9499 040 50611
DPROG ( digital programmer ) / DPROGD ( DPROG data ) 156
Ü