PMA KS 98, Manual

Page: 147 / 246

Configuration DPROG Description Values
PwrUp
Behaviour after mains recovery
Continue program (default)
Cont prog
Search run in the actual segment
Cont seg
Continue at actual time
Cont time
PEnd
Behaviour at program end
stop after program end (default)
Stop
Reset after program end
Reset
Turbo
Time unit
Time = hours : minutes (default)
Hrs:Min
Time = minutes : seconds
Min:Sec
Cascading
Cascading APROGD function blocks permits realization of a programmer with any number of segments. The segment
sequence is dependent of the APROGD function block wiring (
r
see below ).
Recipes
Analog output ‘
ProgNo
‘, at which the actual recipe number is output, and one or several SELV2 function blocks can
be used to select a recipe the block number of which is switched to the APROG input (
r
see below). Selection of the
required recipe is possible via analog input ‘
ProgNo
‘ or recipe number, which can be entered via operation/inter-
face.
a
Recipe switch-over (new
ProgNo
) is effective only after programmer reset.
Entry of the recipe number via operation/interface is possible only, if analog input ProgNo is not connected.
g
If each recipe shall have a separate reset set-point (Wp0), function blocks REZEPT and VPARA can be
used as shown up. Note the calculation order (APROG
r
REZEPT
r
VPARA).
9499 040 50611
Programmer
147 APROG ( analog programmer ) / APROGD ( APROG data )
Recipe 1
Recipe 2
Recipe 3
Example of an analog programmer with 3 recipes à 20 segments
Segment 11 ... 20 Segment 1 ... 10 Segment n ... n+10
Example of an analog programmer with n segments